We designed this custom lift table for a customer to slide a PCB Magazine, which is essentially a circuit board rack holder, directly onto the deck of the table. Once on the table, it needed to be kept in place so that it could be loaded, configured, and assembled prior to being unloaded. The unloading was designed for an operator to lower the latch on the opposite side, and then push the PCB Magazine off of the deck, and onto another surface. Due to the height requirement for the application, a telescoping lift table was needed.

Serial #38654-55 | Custom Telescoping Lift Table

Technical Specifications

Capacity » 1,000 Pounds

Deck » 24″ x 25″ Welded Steel Deck, Non-Rotating

Base » 24″ Square, 2″ Square Structural Steel Legs and Welded Steel Frame. Ø5″ ESD Swivel Casters with Swivel Locks and a Foot Actuated Floor Brake

Raised Height » 36″ at UHMW Working Surface

Lowered Height » 19″ at UHMW Working Surface

Vertical Travel » 17″

Power » Manual Powered Foot Pump

Controls » Foot Pedals – Lift/Lower

Paint » White – RAL #9010

IMPORTANT! The lift on this page is a modified or custom product.  Products of this nature may have very specific features, seen and unseen, that are unique to the original end user’s application. When inquiring about this lift, our customer service team will ask you questions about your application to make sure that you’re getting the right lift for your application with the features you want. Please reference the lift on this page by it’s serial number.